#31
This 3d printed turtle uses the same flex concept from my Mini Monster Truck to create legs that allow the toy to bounce and scurry around when tapped. The head can also retract into the shell.
The model assembles with the printed H-Clips and needs no glue. The parts print without the need for supports.
Attachments
30af6d937f32e37c92d0cd4b5a7bb3c8_preview_featured.jpg
30af6d937f32e37c92d0cd4b5a7bb3c8_preview_featured.jpg (39.61 KiB) Viewed 353 times
1b9bc836f91956089bfa98161dcfc905_preview_featured.jpg
1b9bc836f91956089bfa98161dcfc905_preview_featured.jpg (42.96 KiB) Viewed 353 times
01eba0478e9e7f767025ab8ca0ceba12_preview_featured.jpg
01eba0478e9e7f767025ab8ca0ceba12_preview_featured.jpg (38.07 KiB) Viewed 353 times
(317.27 KiB) Downloaded 55 times
(1.7 MiB) Downloaded 51 times

tretinoin paypal buy malegra 50 kamagra soft […]

I have a printer geeetech prusa i3 pro w I would l[…]

I loaded the firmware and it works well. I can lev[…]

Hi. O noticed here on the forum that a new update […]

ssng hardware film

Whatever request a lot more clearness close to the[…]