By Hayley
I have been hesitant to include these because there are more settings specific to your printer/filament that you'll need to modify than there are necessary to printing the trees. So PLEASE be aware that these are not magic files that will allow you to print these trees properly according to your unique setup. Use them only as a reference if you're unfamiliar with how to tune slicer settings.
As far as the troubles people have had with other slicers, such as Cura, unfortunately, I can't help you there, since I use Simplify3d. I have, however, included the .gcode file for the 160mm tree as a reference for those not using Simplify3d.
(77.62 KiB) Downloaded 252 times
f2641ee5b7d7e270ae83003d9dccf162_preview_featured.jpg (39.74 KiB) Viewed 406 times
535b68730cb275410445565b2fbdb8a2_preview_featured.jpg (57.11 KiB) Viewed 406 times
2ec62550e8b83dd998ba94047993cfed_preview_featured.jpg (68.22 KiB) Viewed 406 times
2b6b72403bad2eb5ccc3fa42ffae92a6_preview_featured.jpg (65.69 KiB) Viewed 406 times

tretinoin paypal buy malegra 50 kamagra soft […]

I have a printer geeetech prusa i3 pro w I would l[…]

I loaded the firmware and it works well. I can lev[…]

Hi. O noticed here on the forum that a new update […]

ssng hardware film

Whatever request a lot more clearness close to the[…]