By Jay Zhou
#33
This is a simple second shower holder I made for my girlfriend so we can have our own individual heights :)

To assemble it you need a M8x30 bolt, 2 washers, a spring and a nut. It's an overkill, but that's what I had handy.

Printer Brand:

SUNLU SL800

Printer:

Tarantula

Rafts:

Doesn't Matter

Supports:

Doesn't Matter

Filament:sunlu PLA
Notes:
I made this from PLA mainly because I had it in pink but for long-term durability ABS would be better.
Attachments
(1.84 MiB) Downloaded 127 times
(1.73 MiB) Downloaded 123 times
(202.25 KiB) Downloaded 110 times
card_preview_image.png
card_preview_image.png (90.26 KiB) Viewed 246 times
featured_preview_image.png
featured_preview_image.png (384.84 KiB) Viewed 246 times

tretinoin paypal buy malegra 50 kamagra soft […]

I have a printer geeetech prusa i3 pro w I would l[…]

I loaded the firmware and it works well. I can lev[…]

Hi. O noticed here on the forum that a new update […]

ssng hardware film

Whatever request a lot more clearness close to the[…]