- Fri Nov 15, 2019 2:49 am
#25
small_thumb_armrings.jpg (2.03 KiB) Viewed 713 times
large_thumb_armrings.jpg (6.37 KiB) Viewed 713 times
large_preview_armrings.jpg (13.92 KiB) Viewed 713 times
card_preview_armrings.jpg (19.3 KiB) Viewed 713 times
Fabbed these up for a build I am doing, only the suit side connector is accurate. The glove side is simplified for installation inside an EVA glove. There are recesses for magnets on each side (x3) for a 6x3mm rare earth magnet to hold the two halves together.
This is the best product i have print with sunlu filament, i like it very much ,hope you also can enjoy i t, if you want it , call me !! haha
This is the best product i have print with sunlu filament, i like it very much ,hope you also can enjoy i t, if you want it , call me !! haha
Attachments
(29.38 KiB) Downloaded 55 times