- Fri Nov 15, 2019 1:37 am
#18
Printable_Wrench_w_more_gap.A.0_preview_featured.jpg (53.22 KiB) Viewed 550 times
50650557c30900a365b0eadc3d8654bf_preview_featured.jpg (81.94 KiB) Viewed 550 times
09d48925bdfd36bd39c7c6014a6f73d5_preview_featured.jpg (86.05 KiB) Viewed 550 times
SUNLU PLA CARBON FIBER
After watching the infamous video from a few years back where Z-Corp prints a fully working wrench i decided i wanted to do the same thing on my own printer.
Now, i am not talking about a "print-several-pieces-and-then-assemble" version which there are already a ton of on the internet.
What i wanted to do was something i could print and that would actually be fully working straight out of the printer.
I like to think i came pretty close. All you need to do is to remove the internal support and your done!
After watching the infamous video from a few years back where Z-Corp prints a fully working wrench i decided i wanted to do the same thing on my own printer.
Now, i am not talking about a "print-several-pieces-and-then-assemble" version which there are already a ton of on the internet.
What i wanted to do was something i could print and that would actually be fully working straight out of the printer.
I like to think i came pretty close. All you need to do is to remove the internal support and your done!
Attachments
(7.8 MiB) Downloaded 264 times